Single Strand Bracelet

Take one end of the Beadalon Wire through a crimp bead, then feed it through the loop on the toggle, then take it back through the crimp bead.
Snug up the wire and crimp the bead with a chain nose pliers.
String on beads, remembering to keep a smaller bead next to the “stick end” of the toggle clasp.
Holding the loose end securely, check length around wrist and add or subtract beads. (The toggle will take up approximately a ½ inch.)
Do the end of the bracelet just like the beginning, taking the wire through the crimp, then thru the toggle, and back thru the crimp again.
Crimp down with the chain nose pliers.
Work approximately a ½ inch of the wire back through your beads and cut the remaining wire off with wire nippers.
You have completed your bracelet and now it’s ready to wear!